Command line python script to discover Ubiquiti devices on the local LAN segment.

Requirements : the script uses the python scapy library to craft and send the raw packet. You can install it with:

pip install scapy

####Ubiquiti Discovery Protocol brief description

Disclaimer: this code is based exclusively on packet sniffing and analysis, there are some fields that remain unknown to me. This code may therefore not be compatible with all devices. I have not tested this on Unifi APs or EdgeOS products.

Ubiquiti discovery works by sending an UDP packet to the local broadcast address (255.255.255.255) on port 10001, containing 4 bytes in the payload, namely 01 00 00 00, and waiting for UDP replies destined to the local broadcast address.

The payload of the reply packet sent by the radio is structured as follows:

• offset 00 (3 bytes) : Ubiquiti discovery reply signature (0x01 0x00 0x00). We'll check this to make sure it's a valid discovery-reply packet.
• offset 03 (1 byte) : Payload size (excluding signature)

Starting at offset 04, the structure of the payload is as follows:

• Field Type (1 byte) : see the UBNT_ constants in the code for the ones I saw and could figure out
• Field data length (2 bytes) : contains the length of this field's data
• Field data (n bytes) : contains the actual field data (eg. radio name, firmware version, etc)

This sequence is repeated for every field in the reply packet.

In case the radio has multiple IPs configured, we'll get several type 02 fields (MAC Address IP Address).

The other field types appear only once in the packets I have observed.