This may belong in a different forum ...

I've recently decided to add Tcl to my toolkit, and combined that with trying out Jim on an embedded project. Blending the two, I'm using jimsh (v. 0.82, built on 4/13/2024) instead of tclsh. Following the tutorial at https://www.tcl.tk/man/tcl8.5/tutorial/tcltutorial.html, the first hiccup came on lesson 19 , where lsearch is covered. Using jimsh, the lsearch command requires the -glob option for the example code to work, whereas with tclsh (v.8.6) the -glob option is on by default. I know Jim is heavily "stripped down"; was this an intentional design decision? If so, is there a global option I can "set and forget"? Am I overlooking something in my naiveté? Here's a command line sequence that shows my concern:

$ cat demo.tcl
set lst {aaa bbbb ccc dd}
set b_ndx [lsearch $lst b*]
puts "b* is in $lst at position $b_ndx"

$ tclsh demo.tcl
b* is in aaa bbbb ccc dd at position 1
$ jimsh demo.tcl
b* is in aaa bbbb ccc dd at position -1

Inserting the -glob option resulted in identical output from tclsh and jimsh.

Assuming this is intentional (and I can think of several reasons it might be), is there somewhere a consolidated list of such differences (such as an Errata page for a book, even though this would not be "errata")