Replies: 5 comments 7 replies
-
|
yes you need to compile ESP3D 3.0 changing in https://github.com/luc-github/ESP3D/blob/3.0/esp3d/configuration.h#L43 to install you can use the MKS way rename the comlied FW to MksWifi.bin and copy to SD and reset board - it will automatically flash ESP board with new FW |
Beta Was this translation helpful? Give feedback.
-
|
Ok, I got it! |
Beta Was this translation helpful? Give feedback.
-
|
I did not tested the orignal Marlin, only MKS one, which should have also some fixes for issues I have raised |
Beta Was this translation helpful? Give feedback.
-
|
Ok! I'll build a bin file and test it on both fw. |
Beta Was this translation helpful? Give feedback.
-
|
here doc done by MKS https://github.com/makerbase-mks/MKS-Robin-Nano-V1.X/wiki/MKS_Robin_WIFI#update-the-esp3d-firmware-to-mks-robin-wifi |
Beta Was this translation helpful? Give feedback.
-
|
Hi! As it's a "config after install" firmware... Please, may you share that "MksWifi.bin" recently compiled file? I have some experience with VS, but Arduino is like come back to the origins (thousand of years ago)... |
Beta Was this translation helpful? Give feedback.
-
|
no there are several possible configurations for esp3d so it is not really a config after install MKS support is just one of them, so sorry I do not provide any binaries or it will be never ending. |
Beta Was this translation helpful? Give feedback.
-
|
@luc-github could you add //MKS_SERIAL Mks protocol (hardcoded to 115200 baoudrate in Mariln) in configuration? or change somehow baoudrate to 115200 when we compile MKS support automatically. It is not obvious and i lost so much time o this ;) thx for all the work. |
Beta Was this translation helpful? Give feedback.
-
|
by default baudrate is 115200 in ESP3D - not sure what you mean |
Beta Was this translation helpful? Give feedback.
-
|
i compiled raw serial first and set 250000 baudrate to match default marlin and check that all is working. later I've tried mks but baudrate was still 25000 and i was sure that there is some conflict or my module is not working, luckily i found info about 115200 in one discussion and everything is working fine, but in my opinion is not obvious. |
Beta Was this translation helpful? Give feedback.
-
|
yes need documentation I agree - but I am busy coding webui right now, and I get used that, even I wrote some text, no one read documentation, so I do not put this in my top priority, but write documentation is in TODO list https://github.com/luc-github/ESP3D/tree/3.0#todo-list-to-move-to-beta in readme that no one read 😉 |
Beta Was this translation helpful? Give feedback.
-
Beta Was this translation helpful? Give feedback.
-
Hi! Can I install ESP3D on the MKS Robin Nano V2 wifi module? Where can I find references?
Beta Was this translation helpful? Give feedback.
All reactions