Skip to content

Use named netns (net namespace) with systemd services!

License

Notifications You must be signed in to change notification settings

g00g1/systemd-named-netns

 
 

Folders and files

NameName
Last commit message
Last commit date

Latest commit

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

Repository files navigation

systemd-named-netns

This project enables you to:

  • Create and delete named netns on the fly like systemd services
  • Start named netns on boot
  • Quickly set up bridging or NAT from netns to host
  • Use named netns in systemd services
    • Enables them to connect to the internet too
    • And you can manually switch to its netns (since they are named)

Installation

Dependencies:

  • Recent version of systemd (newer is better; tested down to v232)
  • iproute2
  • iptables (only if you use default NAT config)
  • /usr/bin/env

For installation, run make install with root privilege.

You ran run make uninstall to remove the systemd units, but the configs located in /etc/default will not be removed.

Quickstart

systemctl start netns-nat@helloworld
chnetns helloworld ip address

Note: Network interface names are derived from the netns name, so do not create netns names longer than 12 characters.

NS Types

It creates a new netns. Use this if you want to customize everything by hand. All other types depend on this.

It creates a new netns with NATed network access (like VMNet8). Use this if you want to get things quickly up and running without any network hassles.

Note:

  • The default configuration will only work for the first netns-nat instance. You need to change the IP addresses if you want 2 or more netns-nat instances running at the same time.
  • This will setup packet forwarding on your Linux kernel, making your host a router (this might cause security problems if set incorrectly)
  • If you want automatic iptables accept rules, set NAT_ACCEPT_TRAFFIC=1

It creates a new netns with a pseudo wire to the host (like VMNet1). Use this if you want to communicate with the program inside the netns but don't want them to have internet access, or if you want to assign routable IPs to a netns.

It bridges the new netns to a Linux bridge. You need to set up the bridge first: see wiki if you are not sure what to do.

MACVLAN Bridge ([email protected])

Alternative to NSType bridge. A MACVLAN Bridge allows you to create multiple interfaces with different Layer 2 (that is, Ethernet MAC) addresses on top of a single NIC. MACVLAN is a bridge without an explicit bridge device.

For netns-mvbr, ${MACVLAN_BRIDGE} will be the bridge device (usually your physical NIC device).

Note that any MACVLAN devices in other netns's will be able to communicate each other and the outside world but NOT the bridge device. If you want to enable communication with the root netns, you can add a MACVLAN device in the root netns and use that instead of the MACVLAN bridge device.

Resources

References

About

Use named netns (net namespace) with systemd services!

Resources

License

Stars

Watchers

Forks

Releases

No releases published

Packages

No packages published

Languages

  • Shell 78.1%
  • Makefile 21.9%