The official release of the Voron Zero 3d printer. You can find the BOM in the configurator located at the Voron Design website.

The current revision is V0.1.

• Compact and portable
• 120x120x120 build volume
• CoreXY
• Low mass direct drive extruder
• Enclosed chamber
• 24v DC bed simplifies electronics
• Klipper firmware

A majority of the printed parts have changed. The configurator will give you an idea of parts needed if you are upgrading from V0.0.

Toolhead

• New design: Mini Afterburner
• Direct Drive Extruder with BMG gears and pancake motor with 10 tooth spur gear
• Improved part cooling ducts (fans are same as V0.0)
• Supports Mosquitto, Dragon, Dragonfly mounts
• V6 mount too large for DDE (bowden still an option)

Z motor

• Simplified to use Nema17 integrated T8x8 200mm leadscrew and printed mount (highly recommended upgrade)

Drive units

• A/B steppers changed to larger 40Ncm motors for increased torque (optional upgrade)
• Parts are now embossed with “A” or “B” respectively to avoid improper assembly
• Motor screws are countersunk to add more thread engagement
• Panel mount point added

Frame

• No changes

Electronics

• Move from AC to 24v 60 watt DC bed (no more SSR)
• 150 watt PSU (larger to support DC bed)
• Fused AC power inlet (now with switch)
• SKR moves to rear compartment and Mini E3 V2.0 now spec
• PSU terminal cover

Tophat

• All panels have changed
• Front and rear are now straight vertical to accommodate new toolhead
• Sides went from 15° to 10°
• 10mm taller all around
• Lower panel clips are built into frame mounts

Panels/clips

• Front deck panel is unchanged
• Mid and back panel has various holes removed (can use your V0.0 panels)
• Rear deck panel is gone
• Motor panel is added (can be printed later)
• Side windows and door are unchanged
• Rear upper panel clips have an added mount point

X/Y Joints

• Hex nuts replaced with threaded inserts
• Idlers replaced by F623 bearing stack (hole adjusted to align perfectly in CAD)
• Endstop block changed to be compatible with DD toolhead
• Inaccessible bottom gantry screw holes removed

Bed Assembly

• Rear mounts extended 3mm to account for DD toolhead position changes
• Z chain mount adjusted to accommodate off-the-shelf chain or printed beltchain
• Zip tie mounts added for cable routing
• Removed horizontal bolt hole to prevent over-constraining assembly
• Front mount reduced in size for less plastic use
• Printed thumb screws for bed adjustments

Feet/Skirts

• Extended to accommodate 34mm Z motor

Front Idlers

• No changes

See https://github.com/VoronDesign/Voron-0/releases/tag/V0.0r1

See https://github.com/VoronDesign/Voron-0/releases/tag/V0.0