A simple web server that lets you blink an LED via the web.
This sketch will print the IP address of your board (once connected) to the Serial monitor.
From there, you can open that address in a web browser.
to turn on and off the LED on pin 9.

If the IP address of your shield is yourAddress:

• http://yourAddress/H turns the LED on
• http://yourAddress/L turns it off

This example is written for a network using WPA encryption.
For WEP or WPA, change the Wifi.begin() call accordingly.

Circuit:

• Arduino Primo or Uno WiFi Developer Edition (with WiFi Link firmware running)
• LED attached to pin 9

also you can see clip of testing this code on my youtube channel:
https://www.youtube.com/watch?v=K0I9b7xwXck

for career service polimi challenge