Copyright (c) 2013-2016 SURFnet bv

All rights reserved. This software is distributed under a BSD-style license. For more information, see LICENSE

1. INTRODUCTION ===============

DNS-based Authentication of Named Entities (DANE) is a mechanism that allows the Domain Name System (DNS) to be used to furnish authenticated information about hosts. RFC 6698 specifies the DANE TLSA record type that can be used to store information about relating to the certificate used to secure TLS connections to a specific service on a host.

To make optimal use of this new facility, the danish tool helps users by generating TLSA or SMIMEA records and by checking certain properties of certificates. The tool was specifically designed to be integrated into an automated DNS zone generation chain. Apart from being able to generate TLSA and SMIMEA records from X.509 certificates danish is also able to:

• Check if a certificate has expired
• Check if the hostname for which a TLSA record is created matches with the certificate
• Check if the e-mail address for which an SMIMEA record is created matches with the certificate
• Check if a certificate matches with the certificate signing request (CSR) used to to request the certificate from a certificate authority

2. PREREQUISITES ================

To build the program:

• POSIX compliant build system
• OpenSSL (>= 0.9.8), the Open Source toolkit for SSL/TLS

3. BUILDING ===========

To build the danish tool, execute the following commands:

./autogen.sh
./configure
make

4. INSTALLING =============

To install the library as a regular user, run:

sudo make install

If you are root (administrative user), run:

make install

5. USING THE TOOL =================

For more information on the danish tool, please consult the manual page by executing:

man 1 danish

6. INTEGRATING THE TOOL WITH YOUR SCRIPTS =========================================

The danish tool was designed with integration in a DNS zone publication tool chain in mind. To this end, it can run certain checks on the certificates for which it generates TLSA records. Depending on which checks were run and the outcome of those checks, danish will set its exit status. This can be used to make decisions about whether or not to include a TLSA record in a DNS zone. The danish tool supports 4 checks listed in section 1 of this README document.

Depending on the outcome of these checks danish may return a combination of one or more of the following exit status values:

• CERT_NOT_VALID (0x00000001) This exit status is set if the certificate has expired
• CERT_NAME_MISMATCH (0x00000002) This exit status is set if the hostname for which the TLSA record is created does not match any of the names specified in the subject or subjectAltName of the certificate
• CERT_CSR_MISMATCH (0x00000004) This exit status is set if the certificate does not match the certificate signing request specified on the command-line
• CERT_ADDR_MISMATCH (0x00000008) This exit status if set if the specified e-mail address for which the SMIMEA record is created does not match any of the e-mail addresses in the subject or subjectAltName of the certificate
• CERT_FATAL_ERROR (0x80000000) This exit status is set if danish encountered a blocking issue while checking the certificate or generating the TLSA record

Multiple exit statuses may be combined using a logical OR operation; thus, if a certificate has expired and the certificate does not match the certificate signing request danish will return:

CERT_NOT_VALID | CERT_CSR_MISMATCH = 0x00000005

7. CONTACT ==========

Questions/remarks/suggestions/praise regarding this tool can be sent to:

Roland van Rijswijk-Deij [email protected]