This directory contains the resources needed to build the Kata Containers snap image.

Kata Containers can be installed in any Linux distribution that supports snapd. For this example, we assume Ubuntu as your base distro.

$ sudo apt-get --no-install-recommends install -y apt-utils ca-certificates snapd snapcraft

You can install the Kata Containers snap from the snapcraft store or by running the following command:

$ sudo snap install kata-containers --classic

Run next command at the root directory of the packaging repository.

$ make snap

To install the resulting snap image, snap must be put in classic mode and the security confinement must be disabled (--classic). Also since the resulting snap has not been signed the verification of signature must be omitted (--dangerous).

$ sudo snap install --classic --dangerous kata-containers_[VERSION]_[ARCH].snap

Replace VERSION with the current version of Kata Containers and ARCH with the system architecture.

By default Kata Containers snap image is mounted at /snap/kata-containers as a read-only file system, therefore default configuration file can not be edited. Fortunately kata-runtime supports loading a configuration file from another path than the default.

$ sudo mkdir -p /etc/kata-containers
$ sudo cp /snap/kata-containers/current/usr/share/defaults/kata-containers/configuration.toml /etc/kata-containers/
$ $EDITOR /etc/kata-containers/configuration.toml

The path to the runtime provided by the Kata Containers snap image is /snap/kata-containers/current/usr/bin/kata-runtime. You should use it to run Kata Containers with docker and Kubernetes.

You can remove the Kata Containers snap by running the following command:

$ sudo snap remove kata-containers

The miniOS image is not included in the snap image as it is not possible for QEMU to open a guest RAM backing store on a read-only filesystem. Fortunately, you can start Kata Containers with a Linux initial RAM disk (initrd) that is included in the snap image. If you want to use the miniOS image instead of initrd, then a new configuration file can be created and configured.