#define DEBUG 1

#define MAXZONES 4 // could go up to 8, if not using WS2801 pixels

#define MAXSECTIONS 16 // don't go wild; 9 sections per zone/LED strip is enough

extern uint8_t numZones; // number of zones (LED strips), each zone requires a GPIO pin (or two)

extern uint16_t numLEDs[]; // number of pixels in each zone

extern uint8_t numSections[]; // number of sections in each zone

extern uint16_t sectionStart[][MAXSECTIONS]; // start pixel of each section in each zone

extern uint16_t sectionEnd[][MAXSECTIONS]; // last pixel of each section in each zone

extern char zoneLEDType[][7]; // LED type for each zone (WS2801, WS2811, WS2812, ...)

// EEPROM layout:

// [0-2] esp ................ verification string

// [3-5] 999 ................ Domoticz idx

// [6] 9 ................ number of used zones

// [7-12] XXXXXX ............. zone 1 LED type (WS2801 (only on zone 0), WS2811, WS2812)

// [13-15] 999 ................ number of LEDs in zone

// [16-18] 999 ................ start of section 1

// [19-21] 999 ................ start of section 2

// [22-24] 999 ................ start of section 3

// [25-27] 999 ................ start of section 4

// [28-30] 999 ................ start of section 5

// [31-33] 999 ................ start of section 6

// [34-36] 999 ................ start of section 7

// [37-39] 999 ................ start of section 8

// [40-42] 999 ................ start of section 9

// [43-48] XXXXXX ............. zone 2 LED type

// ....

typedef struct ZONE_DATA_T {

} zone_data_t;

typedef struct EEPROM_DATA_T {

} eeprom_data_t;

extern eeprom_data_t e;

#define EEPROM_SIZE sizeof(eeprom_data_t) // limit is 512 bytes