Download Marlin Firmware. Reset settings with M502 and M500 after flashing with new firmware.

This is for a Robo 3D R1 with the following mods:

• Buildtak FlexPlate System 9x10
• 300mm Y-Axis Linear Rods
• RepRap Smart Controller
• OctoPrint

1. Robo 3D needed a 10x10 FlexPlate but the 9x10 was a donation.
2. 300mm rods were a little shorter than the stock rods so we had to move 2 bed magnets to accomodate. Y_BED_SIZE was reduced to 200 for this reason.

#define BAUDRATE 115200

#define CUSTOM_MACHINE_NAME "Robo 3D R1 "

//============================= Thermal Settings ============================ #define TEMP_SENSOR_BED 1

//============================== Movement Settings ========================== #define DEFAULT_AXIS_STEPS_PER_UNIT { 80, 80, 2560, 723.38 }

//============================= Z Probe Options ============================= #define FIX_MOUNTED_PROBE

#define NOZZLE_TO_PROBE_OFFSET { 0, 0, 0 }

#define PROBING_MARGIN 35

#define XY_PROBE_FEEDRATE (200*60)

#define INVERT_X_DIR true

#define INVERT_Y_DIR false

#define INVERT_Z_DIR true

#define X_BED_SIZE 220

#define Y_BED_SIZE 200

#define MIN_SOFTWARE_ENDSTOPS false

//=============================== Bed Leveling ============================== #define AUTO_BED_LEVELING_BILINEAR

#define ENABLE_LEVELING_AFTER_G28

#define PREHEAT_BEFORE_LEVELING

#define LCD_BED_LEVELING

#define Z_SAFE_HOMING

//============================= Additional Features =========================== `#define PREHEAT_2_LABEL "PETG"

#define PREHEAT_2_TEMP_HOTEND 240

#define PREHEAT_2_TEMP_BED 75

#define PREHEAT_2_TEMP_CHAMBER 35

#define PREHEAT_2_FAN_SPEED 0 // Value from 0 to 255

//============================= LCD and SD support ============================ #define SDSUPPORT

#define SD_CHECK_AND_RETRY

#define SLIM_LCD_MENUS

#define SPEAKER

//======================== LCD / Controller Selection ========================= //======================== (Character-based LCDs) ========================= #define REPRAP_DISCOUNT_SMART_CONTROLLER

#define BABYSTEPPING

#define BABYSTEP_MILLIMETER_UNITS

#define BABYSTEP_MULTIPLICATOR_Z 0.05

#define BABYSTEP_MULTIPLICATOR_XY 0.05

#define HOST_ACTION_COMMANDS